NEC uPD78P078 - Manual (Page 349)

349
CHAPTER 17 SERIAL INTERFACE CHANNEL 0 (
µ
PD78078 SUBSERIES)
Timing Chart Definition Signal Name
Output
Device
Output
Condition
Effects on Flag Meaning of Signal
Synchronous clock to output
address/command/data, ACK
signal, synchronous BUSY
signal, etc. Address/
command/data are transferred
with the first eight synchronous
clocks.
8-bit data to be transferred
in synchronization with
SCK0 after output of only
CMD signal without REL
signal output
Master
Numeric values to be
processed with slave
or master device
Serial clock
(SCK0)
Timing of signal
output to serial data
bus
Address value of
slave device on the
serial bus
Address
(A7 to A0)
8-bit data to be transferred
in synchronization with
SCK0 after output of REL
and CMD signals
Master
Commands
(C7 to C0)
Instructions and
messages to the
slave device
Master/
slave
Data
(D7 to D0)
8-bit data to be transferred
in synchronization with
SCK0 without output of
REL and CMD signals
Table 17-3. Various Signals in SBI Mode (2/2)
When CSIE0 = 1,
execution of
instruction for
data write to
SIO0 (serial
transfer start
instruction) Note 2
Notes 1. When WUP = 0, CSIIF0 is set at the rising edge of the 9th clock of SCK0.
When WUP = 1, an address is received. Only when the address matches the slave address register (SVA) value, CSIIF0 is set (when they do not
match, RELD is cleared).
2. In BUSY state, transfer starts after the READY state is set.
Master
CSIIF0 set (rising
edge of 9th clock
of SCK0) Note 1
SCK0
SB0 (SB1)
1 2 7 8
SCK0
SB0 (SB1)
1 2 7 8
CMD
SCK0
SB0 (SB1)
1 2 7 8
REL CMD
SCK0
SB0 (SB1)
1 2 7 8 9 10