NEC uPD78P078 - Manual (Page 625)

625
APPENDIX E REVISION HISTORY
Edition Major revisions from previous edition Chapter
Fourth The following products have been changed from “under
development” to “already developed”.
µ
PD78078Y Subseries:
µ
PD78076Y, 78078Y, 78P078Y
The following package has been added to the
µ
PD78078Y
Subseries.
100-pin plastic LQFP (Fine pitch)
(14 x 14 mm, resin thickness 1.4 mm)
Block diagrams of ports have been changed.
Figure 6-5. Block Diagram of P20, P21, P23 to P26,
Figure 6-6. Block Diagram of P22 and P27,
Figure 6-7. Block Diagram of P20, P21, P23 to P26,
Figure 6-8. Block Diagram of P22 and P27,
Figure 6-9. Block Diagram of P30 to P37,
Figure 6-16. Block Diagram of P71 and P72,
Figure 6-20. Block Diagram of P100 and P101
Table 7-2. Relationship between CPU clock and Minimum
Instruction Execution Time has been added.
Precautions for changing the operation mode of the serial
interface channel 0 have been added.
Release conditions of busy mode of the serial interface channel
0 (in SBI mode) have been changed.
Cautions for the case that bus release signal (REL) and command
signal (CMD) are misrecognized due to the bus line changing
timing has been added.
Conditions and timings for the generation of interrupt request
(INTSR, INTSER) when a reception error is generated have
been corrected.
Precautions for using UART mode have been added.
Precautions for replacing PROM versions with mask ROM versions
have been added.
APPENDIX A DIFFERENCES BETWEEN
µ
PD78078,
78075B SUBSERIES and
µ
PD78070A has been added.
Entirely revised: Supports in-circuit emulator IE-78K0-NS
Entirely revised: Fuzzy inference developing support system
has been deleted.
Throughout
CHAPTER 6 PORT FUNCTION
CHAPTER 7
CLOCK GENERATION CIRCUIT
CHAPTER 17
SERIAL INTERFACE CHANNEL 0
(
µ
PD78078 SUBSERIES),
CHAPTER 18
SERIAL INTERFACE CHANNEL 0
(
µ
PD78078Y SUBSERIES)
CHAPTER 17
SERIAL INTERFACE CHANNEL 0
(
µ
PD78078 SUBSERIES)
CHAPTER 20
SERIAL INTERFACE CHANNEL 2
CHAPTER 27
µ
PD78P078, 78P078Y
APPENDIX A DIFFERENCES
BETWEEN
µ
PD78078, 78075B
SUBSERIES AND
µ
PD78070A
APPENDIX B
DEVELOPMENT TOOLS
APPENDIX C
EMBEDDED SOFTWARE