NEC uPD78P078 - Manual (Page 35)

35
CHAPTER 1 OUTLINE (
µ
PD78078 SUBSERIES)
1.4 Quality Grade
Part number Package Quality grades
µ
PD78076GC-xxx-7EA 100-pin plastic QFP (Fine pitch) (14 x 14 mm, resin thickness 1.45 mm) Standard
µ
PD78076GC-xxx-8EU Note 100-pin plastic LQFP (Fine pitch) (14 x 14 mm, resin thickness 1.4 mm) Standard
µ
PD78076GF-xxx-3BA 100-pin plastic QFP (14 x 20 mm, resin thickness 2.7 mm) Standard
µ
PD78078GC-xxx-7EA 100-pin plastic QFP (Fine pitch) (14 x 14 mm, resin thickness 1.45 mm) Standard
µ
PD78078GC-xxx-8EU Note 100-pin plastic LQFP (Fine pitch) (14 x 14 mm, resin thickness 1.4 mm) Standard
µ PD78078GF-xxx-3BA 100-pin plastic QFP (14 x 20 mm, resin thickness 2.7 mm) Standard
µ PD78P078GC-7EA 100-pin plastic QFP (Fine pitch) (14 x 14 mm, resin thickness 1.45 mm) Standard
µ
PD78P078GC-8EU Note 100-pin plastic LQFP (Fine pitch) (14 x 14 mm, resin thickness 1.4 mm) Standard
µ
PD78P078GF-3BA 100-pin plastic QFP (14 x 20 mm, resin thickness 2.7 mm) Standard
µ
PD78P078KL-T 100-pin ceramic WQFN (14 x 20 mm) Not assured
(for function evaluation only)
Note Under development
Caution Of the above members, the following device with the suffix KL-T should be used only for
experiment or function evaluation, because it is not intended for use in equipment that will be
mass-produced and require high reliability.
•
µ
PD78P078KL-T
Remark xxx indicates ROM code suffix.
Please refer to “Quality Grades on NEC Semiconductor Devices”(C11531E) published by NEC Corporation to know the
specification of quality grade on the devices and its recommended applications.