NEC uPD78P078 - Manual (Page 555)

555
CHAPTER 25 RESET FUNCTION
Table 25-1. Hardware Status after Reset (1/3)
Hardware Status after Reset
Program counter (PC) Note 1 The contents of reset vector tables
(0000H and 0001H) are set.
Stack pointer (SP) Undefined
Program status word (PSW) 02H
Data memory Undefined Note 2
General register Undefined Note 2
Ports 0 to 3, Port 7, 9, 10, 12, 13 00H
(P0 to P3, P7, P9, P10, P12, P13)
Port 4 to Port 6, Port 8 (P4 to P6, P8) Undefined
Port mode register (PM0 to PM3, PM5 to PM10, PM12, PM13) FFH
Pull-up resistor option register (PUOH, PUOL) 00H
Processor clock control register (PCC) 04H
Oscillation mode selection register (OSMS) 00H
Memory size switching register (IMS) Note3
Internal expansion RAM size switching register (IXS) 0AH
External bus type selection register (EBTS) 00H
Memory expansion mode register (MM) 10H
Oscillation stabilization time select register (OSTS) 04H
Timer register (TM0) 00H
Capture/compare register (CR00, CR01) Undefined
Clock selection register (TCL0) 00H
Mode control register (TMC0) 00H
Capture/compare control register 0 (CRC0) 04H
Output control register (TOC0) 00H
Timer register (TM1, TM2) 00H
Compare registers (CR10, CR20) Undefined
Clock select register (TCL1) 00H
Mode control registers (TMC1) 00H
Output control register (TOC1) 00H
RAM
Port (Output latch)
16-bit timer/event counter
8-bit timer/event counter
1 and 2
Notes 1. During reset input or oscillation stabilization time wait, only the PC contents among the hardware
statuses become undefined. All other hardware statuses remains unchanged after reset.
2. In the standby mode, the status before the reset is held even after the reset.
3. The values after reset depend on the product.
µ
PD78076, 78076Y : CCH
µ
PD78078, 78078Y : CFH
µ
PD78P078, 78P078Y : CFH