NEC uPD78P078 - Manual (Page 6)

6
Major Revisions in This Edition
Page Description
Throughout The following products have been changed from “under development” to “already developed”.
µ
PD78078Y Subseries:
µ
PD78076Y, 78078Y, 78P078Y
The following packages have been added to the µ PD78078Y Subseries.
100-pin plastic LQFP (Fine pitch) (14 × 14 mm, resin thickness 1.4 mm)
p. 139 to 143, Block diagrams of ports have been changed.
149, 153 Figure 6-5. Block Diagram of P20, P21, P23 to P26, Figure 6-6. Block Diagram of P22 and P27,
Figure 6-7. Block Diagram of P20, P21, P23 to P26, Figure 6-8. Block Diagram of P22 and P27,
Figure 6-9. Block Diagram of P30 to P37, Figure 6-16. Block Diagram of P71 and P72,
Figure 6-20. Block Diagram of P100 and P101
p. 169 Table 7-2. Relationship between CPU Clock and Minimum Instruction Execution Time has been
added.
p. 181 8.1 Outline of Timers Incorporated into
µ
PD78078, 78078Y Subseries has been added.
p. 241 Figure 9-10. Square Wave Output Operation Timing has been added.
p. 262 Figure 10-13. Square Wave Output Operation Timing has been added.
p. 277 Figure 12-1. Block Diagram of Watchdog Timer has been corrected.
p. 316, 366 Precautions have been added to 17.1, 18.1 Serial Interface Channel 0 Functions.
p. 323, 374 Precautions have been added to 17.3 (2), 18.3 (2) Serial Operating Mode Register 0 (CSIM0).
p. 372 Note about the BSYE flag in Figure 17-5. Serial Bus Interface Control Register Format has been
changed.
p. 336 Precautions have been added to 17.4.3 (2) (a) Bus release signal (REL), (b) Command signal
(CMD).
p. 449 19.4.3 (3) (d) Busy control option, (e) Busy & strobe control option, and (f) Bit slippage
detection function have been changed to (4) Synchronization control, and the explanation has
been improved.
p. 481 20.4.2 (2) (d) Reception
Conditions of INTSR generation when receive error occurrs has been corrected.
p. 482 Figure 20-10. Receive Error Timing has been corrected, and note has been added.
p. 490 20.4.3 (3) MSB/LSB switching as the start bit has been added.
p. 491 20.4.4 Restrictions on using UART mode has been added.
p. 569 Precautions have been added to Table 27-1. Differences between
µ
PD78P078, 78P078Y and Mask
ROM Versions.
p. 597 APPENDIX A DIFFERENCES BETWEEN
µ
PD78078, 78075B SUBSERIES AND
µ
PD78070A has
been added.
p. 599 to 612 APPENDIX B DEVELOPMENT TOOL
Entirely revised: Supports in-circuit emulator IE-78K0-NS
p. 613, 614 APPENDIX C EMBEDDED SOFTWARE
Entirely revised: Fuzzy inference developing support system has been deleted.
The mark shows major revised points.