NEC uPD78P078 - Manual (Page 604)

604
APPENDIX B DEVELOPMENT TOOLS
B.2 PROM Writing Tools
B.2.1 Hardware
PG-1500
PROM Programmer
PA-78P078GC
PA-78P078GF
PA-78P078KL-T
PROM Programmer Adapter
A PROM programmer that, by connecting the attached board and separately
available PROM programmer adapter, is capable of programming single-
chip microcomputers incorporating a PROM on stand-alone basis or
through operation from the host machine.
Also capable of programming typical 256-Kbit to 4-Mbit PROM.
A PROM programmer adapter for the
µ
PD78P078 and
µ
PD78P078Y.
Used connected to the PG-1500.
PA-78P078GC : 100-pin plastic QFP (GC-7EA, GC-8EU type)
PA-78P078GF : 100-pin plastic QFP (GF-3BA type)
PA-78P078KL-T : 100-pin ceramic WQFN (KL-T type)
B.2.2 Software
PG-1500 Controller Connects PG-1500 and the host machine with serial and parallel interface,
and controls the PG-1500 on the host machine.
The PG-1500 controller is a DOS-based application. Use it with the DOS
prompt on Windows.
Part number:
µ
SxxxxPG1500
Remark xxxx in the part number differs depending on the host machine and OS used.
µ
Sxxxx PG1500
xxxx Host Machine OS Supply Media
5A13 PC-9800 series MS-DOS 3.5-inch 2HD FD
(ver. 3.30 to ver. 6.2 Note )
5B13 IBM PC/AT and Refer to B.4 3.5-inch 2HC FD
compatibles
Note MS-DOS ver. 5.0 or later has a task swap function, but it cannot be used with the
above software.