Ricoh Aficio 340 - Manual (Page 325)

PRINTING FUNCTIONS
69
3
Note
❒ By default this feature is turned
off. Switch it on with the User Pa-
rameters.
⇒
P.203 “Changing the
User Parameters”
Reference
P.67 “Page Separation and Length Re-
duction (not available in some coun-
tries)”
TSI Print
Usually the sender's TTI is printed on
received messages. If the sender has
not programmed their TTI, you will
not be able to identify them. Howev-
er, if you turn this feature on, the
sender's RTI P.193 “RTI/TTI” or CSI
P.193 “RTI/TTI” is printed instead so
you can find out where the message
came from.
Note
❒ You can turn it on or off with the
User Parameters.
⇒
P.203 “Chang-
ing the User Parameters”
CIL/TID Print
The ISDN unit is required to use this
function.
Two features are provided for identi-
fication of messages received by G4
(ISDN). If turned on, this information
will be printed on every page. Turn
CIL and TID on and off with the User
Parameters.
⇒
P.203 “Changing the
User Parameters”
The CIL (Call Identification Line) re-
fers to the combination of the receiv-
er's own fax number, name, the
sender's own fax number and name,
time, and page number. The default
setting is on. The TID refers to the
name registered by the sender in their
TTI. The default setting is on.
Limitation
❒ This feature is available only when
receiving in G4 mode.
Note
❒ You can turn CIL off with the User
Parameters.
When There is No Paper of the Correct Size
If there is no paper in your machine that matches the size of a received message,
the machine will choose a paper size based upon the paper you have available.
For example, if your machine has LG (8.5
×
15”)
L installed and you receive an
LT (8.5
×
14”)
L size message, check the LT column of the table below. The pa-
per size at the top has the highest priority. In this case, since LG (8.5
×
14”)
L is
higher priority than DLT (11
×
17”)
K, the message is printed on LG (8.5 ×
14”)
L.
❖ ❖ ❖ ❖ Priority Table
Page Reduction Disabled
Reduction in Sub-scan Direction Enabled
Page Separation Threshold 20 mm
Width or Length Priority Width