IAI America PSEL - Manual (Page 450)

440
Appen
dix
(In the panel window, the three digits after “E” indicate an error number.)
Error No. Error name Description, action, etc.
A02 Abnormal system-memory backup battery voltage The voltage of the system-memory backup battery is low. Replace the battery.
(Below the minimum data-backup voltage)
A03 Absolute-data backup battery voltage-low warning (Driver analysis) The voltage of the absolute-data backup battery is low. Check the battery
connection or replace the battery.
A04 System mode error at core update An update command was received when the system was not in the core update
mode. Before updating the core, confirm that a chip resistance for setting core
update mode is provided on the board. (For maintenance)
A05 Motorola S record format error The update program file is invalid. Check the file.
A06 Motorola S checksum error The update program file is invalid. Check the file.
A07 Motorola S load address error The update program file is invalid. Check the file.
A08 Motorola S write address over error The update program file is invalid. Check the file.
A09 Flash-ROM timing limit over error (Write) Error writing the flash ROM
A0A Flash-ROM timing limit over error (Erase) Error erasing the flash ROM
A0B Flash-ROM verify error Error erasing/writing the flash ROM
A0C Flash-ROM ACK timeout Error erasing/writing the flash ROM
A0D Head sector number specification error Error erasing the flash ROM
A0E Sector count specification error Error erasing the flash ROM
A0F Write-destination offset address error (Odd-numbered address) Error writing the flash ROM
A10 Write-source data buffer address error (Odd-numbered address) Error writing the flash ROM
A11 Invalid core-code sector block ID error The core program already written to the flash ROM is invalid.
A12 Core-code sector block ID erase count over The number of times the flash ROM can be erased was exceeded.
A13 Flash-ROM write request error when erase is incomplete When updating, a flash-ROM write command was received before a flash-ROM
erase command. Check the update program file and perform update again.
A14 Busy-status reset timeout error at EEPROM write A busy-status reset timeout occurred after executing EEPROM write.
A15 EEPROM write request error due to no-EEPROM in target An EEPROM write request was received for a driver or other unit with CPU not
equipped with EEPROM.
A16 EEPROM read request error due to no-EEPROM in target An EEPROM read request was received for a driver or other unit with CPU not
equipped with EEPROM.
A17 Message checksum error (IAI protocol reception) The checksum in the received message is invalid.
A18 Message header error (IAI protocol reception) The header in the received message is invalid. Invalid header position (message
is 9 bytes or less) is suspected, among other reasons.
A19 Message station number error (IAI protocol reception) The station number in the received message is invalid.