IAI America IA-T-XD - Manual (Page 39)

9. Simple Operation Procedure
30
@B@

@B@
/



Press the F1 key (Mdi).
The above is the display of a 2 axis
controller. Nothing displays in the 3rd
and 4th axes data location.
@B@
6@
3
@

The cursor is placed at position No.
If there is no data, x.xxx will be displayed. Press
the return key and place the cursor at first axis
position data.
* If the data is already input , write over (original
data is gone) or use the PAGE UP · PAGE
DOWN keys to be placed at x.xxx and then input
the data.
Clear all axis input data by pressing the F1 (Clr)
key twice. You can clear the controller data with
(Clr) key even if the WRT key is not pressed.
When input the 5th and 6th axes data, press the
F4 (Axis) key to switch the display to the 5th and
6th axes data display screen.
(The F4 (Axis) key is used to switch the 1st to 4th
axes display screen to the 5th and 6th axes
display screen.)
Position No.
Axis No. displayed
First axis data
Second axis data
Third axis data Fourth axis data
31
㽲
/

<@

<B
@

Input 0 (number) and press the return key, 0.000 will
be displayed and then the axis No. changes to 2 and
the cursor position moves to the second axis position
data.
* Position data can be input as 7 digit real having 3 decimal places. This is the maximum
amount and range is different by actuator type, so, please check the catalogs.
Input 50 at the second axis position data and press
return key. (*Every press of return key, the cursor
position moves. When you miss input, place the
cursor to the miss input position and write over.)
Also you can return the input data to x.xxx with the
F3 (Canc) key.
Transmit the data with the WRT key, position No.
forwards 1 and becomes 2.
* If you change the screen with the PAGE UP ·
PAGE DOWN or ESC keys before transmitting
the data, the input data will be invalid.
㽳
/

<@

B@
@

Input 50 on the first axis position data and press
return key.
Axis No. on the cursor location
Position No. 2