IAI America IA-T-XD - Manual (Page 72)

11. Position Edit
64
㽴
.@@B
?@C?

Move the actuator continuously to the location of the position data transmitted to the controller.
Select the position No. to move first in the teaching
screen condition and press return key.
Press the ON/OFF key to turn the servo ON.
To confirm the servo ON/OFF status, press the F1
(Disp) key.
Press the F1 (Cont) key.
When you change the moving velocity, press the F2
(Jvel) key to move to the velocity change screen.
Input changed data with the 10 keys and press the
return key. After changing, return to the previous
screen with the ESC key.
(The moving velocity is set 50mm/sec at the diagram
on the left.)
Continuous movement starts by pressing MOVE key.
During continuous movement, the display changes
to the current position display. To stop, press the
STOP key.
To re-start continuous movement, press the MOVE
key.
Note: Please take note that it may take a few
seconds before movement start after the
MOVE key is pressed. (The time elapsed until
movement start varies according to the
number of registered position data.)
Moving velocity 50mm/sec
Position No. you’d like to move first