IAI America IA-T-XD - Manual (Page 47)

9. Simple Operation Procedure
38
Select the F1 key (Edit) at the mode selection
screen.
Select the F2 key (Prog) at the Edit Mode screen.
Select the F1 key (Mdfy) on the program edit and
new creation screen.
Change to the program No. input screen. The cursor
is located at the program No. Move the cursor to the
step No. with return key.
* If the program data is already input, write over
(the data will be gone) or select the program No.
which has no program data. The cursor location on
program No. or step No. can be changed with PAGE
UP · PAGE DOWN keys.
Also, you can change the program No. and step No.,
by pressing the return key after the 10 key input.
Program No.
Step No.
The number of step
saved at the controller
39
The Cursor moves to the appropriate step No. Press
the return key.
3
@??B

Commands are displayed in the function key area.
2@D
@
B

@??

㽲
When the cursor is located at commands input
locations, commands are displayed in
alphabetical order by pressing SF key.
㽳 Alphabets are allocated on 10 keys. (ex. GHI are
allocated to 9.) When the cursor is located at
command input location, display the first
command word which starts with each alphabet in
the function key area each time by pressing the
10 key.
Display the command you’d like to input in the
function key area with the steps of 㽲 and 㽳
above and press the corresponding function key.
2@D
@
B

@??!
2 

The commands which start with G, H, or I will be
displayed by pressing the 9 key of the 10 keys.
(Some commands can’t be displayed by pressing
one of the 10 keys. In this case, press the SF (shift)
key and one of the 10 keys for more option.)
Display HOME in the function key area and press
the F4 key (HOME). (If you want to backspace
previous operation, press BS key.)
Press the return key.
The command which
starts from G
The command
which starts
from H
The command
which starts
from I