Position edit, 1. mdi (manual direct input) – IAI America IA-T-XD User Manual
Page 63
11. Position Edit
54
㽴
@
Mode Transition:
The cursor is located in the data area (column). Input
the ASCII code by pressing one of 10 keys and
press return key to substitute letters. (Convert
hexadecimal A~F to alphabet with the F1
(Alph/Num) key and then input substitution.)
Move the cursor location with the return key and m
key.
The PAGE UP · PAGE DOWN keys scrolls the
cursor every 20 columns each time they are
pressed .
55
## @B@
### /3
The input value of the position data can be entered with the 10 numeric keys.
For inputting input data for a coordinate by using the 10 numeric keys, please refer to “9. Simple
Operation Procedures.”
How to input Vel (Velocity), Acc (Acceleration), and Dcl (Deceleration) on each position No.
Mdi (Manual Direct Input)
Transit to the Manual Direct Input screen:
Position No. Return
Vel is displayed at the function key area of the data
input screen for each axis. Press the F2 (Vel) key.
H,..H/3
Move the cursor with the return key and input the
value to the required place by using the 10 keys.
Then press the return key.
After input, transmit the data to the controller with the
WRT key.
* If you change the screen with the PAGE UP ·
PAGE DOWN or ESC keys before transmitting
the data, the input data will be invalid.
The position No. will be incremented and the next
input screen, Vel · Acc · Dcl, will be displayed.
Position No.