IDEC MicroSmart Pentra - Manual (Page 135)

A PPLICATION E XAMPLES
7-14 FC5A MicroSmart PID Module User’s Manual FC9Y-B1283
9. User Program Download
From the WindLDR menu bar, select Online > Transfer> Download to open Download dialog box.
Click the check box on the left of Write PID Module parameters after download and click OK button.
The user program will be downloaded to the CPU module. After downloading the user program, the PID
module parameters will be written to the data registers in the CPU module and the PID module
connected to the CPU module.
When program download is successfully completed, the following message will appear. Click OK button
to close the message.
10. Starting Program Control
1. Turn on external input I0 and I3 to enable CH0 and CH1 controls.
2. Turn on external input I2 and I5 to allow auto-tuning (AT) to be performed.
3. Turn on external input I1 and I4 to start the program control for CH0 and CH1 controls.
4. Turn on the load circuit power.
The PID module starts the configured program control from step 0. Auto-tuning (AT) will be performed in
each step. When the program control for CH0 or CH1 is completed, Q1 or Q3 will be turned on,
respectively.