IDEC MicroSmart Pentra User Manual
Page 52
D
EVICE
A
LLOCATION OF
PID
M
ODULE
FC5A MicroSmart PID Module User’s Manual FC9Y-B1283
5-11
0
1
1
2
0
0
1
0
1 2
0
0
1
2
1
2
1
Examples of Program Control Progress
Example 1: Terminate Program Control when Program Ends
The following diagram shows an example of the program control when terminate program control is
selected as the program end action.
Time of steps: Step 0 and 1: 60 minutes, Step 2: 30 minutes, Steps 3 to 9: 0 minute
In this example, D1000 is allocated to the control register and M500 is allocated to control relay.
Note: The PID module executes all steps 0 to 9 even if the step times of steps are zero. When the program control is
terminated, nine is stored in the current step number of block 0.
Current step number
D1006
Control enable bit
D1022.0
Program control bit
D1022.3
Program control bit
(Monitor)
D1009.3
Program hold bit
D1022.4
Advance next step bit
D1022.6
Advance previous step bit
D1022.7
Program end output
D1010.6
The program control is started
from the start of Step 1.
The program control is held at the
40 minutes of remaining time.
The program control is proceeded to
the start of step 1 while the program
hold is maintained.
The program control is proceeded to
the start of step 2 while the program
hold is maintained.
15 sec
45 min
30 sec
30 min
20 min
30 min
5 min
The program hold is canceled, and
the program control is started from
the start of step 2.
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF