IDEC MicroSmart Pentra - Manual (Page 80)

C ONFIGURING PID M ODULE USING W IND LDR
F C5A MicroSmart PID Module User’s Manual FC9Y-B1283 6-15
Offset from
the control
register
Parameter Setting Range R/W
CH0 CH1
(14) +32 +109
Output Manipulated
Variable Rate-of-Change
0 to 100%/sec R/W
(15) +61 +138
Output ON/OFF
Hysteresis
When input range unit is Celsius:
0.1 to 100.0°C
When input range unit is Fahrenheit:
0.1 to 100.0°F
When input is voltage or current:
1 to 1000
R/W
(16) +21 +24
Manual Mode Output
Manipulated Variable
When heating/cooling control is disabled:
Output manipulated variable lower limit to output
manipulated variable upper limit
When heating/cooling control is enabled:
- Cooling output manipulated variable upper limit to
heating output manipulated variable upper limit
R/W
(17) +35 +112
Loop Break Alarm (LA)
Time
0 to 200 minutes R/W
(18) +36 +113
Loop Break Alarm (LA)
Span
When input range unit is Celsius:
0 to 150 °C
(Range with a decimal point: 0.0 to 150.0°C)
When input range unit is Fahrenheit:
0 to 150 °F
(Range with a decimal point: 0.0 to 150.0°F)
When input is voltage or current:
0 to 1500
R/W
(19) +95 – Cooling Method
0: Air cooling
1: Oil cooling
2: Water cooling
R/W
(20) +48 –
Cooling Proportional
Band
0.0 to 10.0 times
(Cooling proportional band is the product of this value
and the heating proportional band)
R/W
(21) +98 –
Cooling Output ON/OFF
Hysteresis
When input range unit is Celsius:
0.1 to 100.0°C
When input range unit is Fahrenheit:
0.1 to 100.0°F
When input is voltage or current:
1 to 1000
R/W
(22) +50 – Overlap/Dead Band
When input range unit is Celsius:
-200.0 to 200.0°C
When input range unit is Fahrenheit:
-200.0 to 200.0°F
When input is voltage or current:
-2000 to 2000
R/W
(23) +91 +168
Program Control Mode
Start Type
0: PV start
1: PVR start
2: SP start
R/W
(24) +96 +173
Set Point (SP) when
Program Control Starts
When input is thermocouple/resistance thermometer:
Set point (SP) lower limit to set point (SP) upper limit
When input is voltage or current:
Linear conversion min. to linear conversion max.
R/W
(25) +92 +169 Step Time Unit
0: Minute
1: Second
R/W
(26) +93 +170 Program End Action
0: Terminate program control
1: Continue program control (Repeat)
2: Hold program control
R/W
(27) +97 +174 Number of Repeats 0 to 10000 times R/W