Display setup, Supervisor code – ZOLL X Series Monitor Defibrillator Rev B User Manual
Page 130
Chapter 4
Supervisor Menu
124
zoll.com
9650-001358-01 Rev. B
Display Setup
The following options allow you to set values related to display.
Display FiCO2
The Display FiCO2 parameter allows you to enable or disable FiCO2 monitoring.
The values for the Display FiCO2 parameter are:
Screen Cycle Display Formats
This Screen Cycle Display Formats parameter allows you to set the screen cycle display
The values for the Screen Cycle Display Formats parameter are:
Default ECG Lead
The Default ECG Lead parameter allows you to set the default ECG Lead cable.
The values for the Default ECGT Lead parameter are:
Enable NVG Mode
The Enable NVG Mode parameter allows you to enable or disable night vision goggle Mode.
The values for the Enable NVG Mode parameter are:
Supervisor Code
The Supervisor Code parameter allows you to set the Supervisor Code needed to access the
Supervisor Menu.
The values for the Supervisor Code parameter are:
Possible Values:
No, Yes
Default:
No
Possible Values:
All Available, Skip Large Numerics
Default:
All Available
Possible Values:
Pads, I, II, III, aVR, aVL, aVF, V, V1, V2, V3, V4, V5, V6
Default:
II
Possible Values:
No, Yes
Default:
No
Possible Values:
Numeric
Default:
Contact the Zoll Technical Support Department if you do not have the
default supervisor code.