ZOLL X Series Monitor Defibrillator Rev B - Manual (Page 9)

9650-001358-01 Rev. B X Series Configuration Manual 3
Chapter 1
Introduction
The X Series
®
unit has many user accessible settings that allow you to configure the device
according to your protocols and local requirements. This manual describes how to view and
modify the X Series configuration settings.
Note: Your unit only contains the features you have purchased. It may not contain all of the
features listed in this manual.
You can view and modify configuration settings through the Setup, Parameter, and Supervisor
menus. The Setup and Parameter menus are available to all users, while the Supervisor menu is
restricted to authorized users and requires a passcode for entry. The Setup menu allows you to
change configuration settings such as display, printer, and trends. The Parameter menus allow
you to change current configuration settings such as NIBP and SpO
2
. The Supervisor menu
allows you to configure default settings such as alarms, NIBP, and Defib/Pacer.
Note: The X Series unit ships from ZOLL with both the default supervisor passcode and the
service passcode set to 1234. ZOLL highly recommends changing the default service
passcode when you receive the unit.
The Parameter menus share many of the same settings as the Supervisor menu. If the shared
settings have been configured in the Supervisor menu, they can be modified in the Parameter
menus, but they will default back to the Supervisor settings once the unit is turned off for two
minutes.
The Setup, Parameter, and Supervisor menus are described in detail in separate chapters of this
manual. These chapters contain information on how to access the menus as well as the settings
that are contained in each menu and their default values.
This chapter contains the following information:
• Overview of the Setup, Supervisor, and Parameter Menus
• Exporting and Importing Configuration Information Using a USB Device
• Restoring Default Values