Yokogawa Standalone MW100 - Manual (Page 108)

App-6
IM MW100-17E
Note
• For INT32 or INT16, only the mantissa of the measured/computed data is acquired. The
decimal place must be obtained separately.
• For FLOAT, the measured/computed data including the decimal place can be acquired.
• The FLOAT and INT32 data domains are set so that they can only be accessed (read/write)
by the unit of two registers.
• Alarm statuses are output in the same format as those described in section 2.3, “Binary
Output.”
Hold Registers
41001 to 41600, and 42001 to 42300 are for functions of firmware version R3.04 or later.
Absolute Relative Allocation Data
Address Address Type
40001 0000 Lower byte of data from communication input channel C001 FLOAT
40002 0001 Upper byte of data from communication input channel C001
: : : :
40599 0598 Lower byte of data from communication input channel C300 FLOAT
40600 0599 Upper byte of data from communication input channel C300
41001 1000 Lower byte of data from communication input channel C001 INT32
41002 1001 Upper byte of data from communication input channel C001
: : : :
41599 1598 Lower byte of data from communication input channel C300 INT32
41600 1599 Upper byte of data from communication input channel C300
42001 2000 Data from communication input channel C001 INT16
: : : :
42300 2299 Data from communication input channel C300 INT16
Appendix 2 Modbus Protocol