Yokogawa Standalone MW100 - Manual (Page 53)

2-3
IM MW100-17E
Response
1
2
3
App App
Index
2.1 Response Format
Data Sum
Sum value of binary data.
• Sum value is calculated only when “calculate sum” is set in the CS command. The value “0”
is stored in the sum value domain when “do not calculate sum” is set.
Flag
Flag value
Bits Notation 0 1 Flag Meaning
7 BO MSB LSB Byte order
6 CS None Y Checksum
5 - - -
4 - - -
3 - - -
2 - - -
1 - - -
0 - - -
• The byte order is the data order of 2 or more bytes including the binary data portion. It
indicates that data is stored in the MSB (top byte) first or LSB (bottom byte) first.
• Checksum indicates whether a sum value is in the header sum and data sum domains, and
if the checksum value (CS) is 0, then 0 is stored in those domains.
• If a dash ( - ) is located in the notation or flag column, the bit is not used. The value is
indefinite.
Identifier
Identifier Binary Data Type Format
0 Unspecified data File
128 Unspecified data Data
129 FIFO data Data
130 The latest measured/computed data Data
131 Latest output data Data
132 FIFO read range Data