Yokogawa Standalone MW100 - Manual (Page 75)

2-25
IM MW100-17E
Response
1
2
3
App App
Index
Output of Modbus Master Logs (FL0, MODBUS_M)
• Output using the FL command.
• Modbus master information logs are output.
Syntax
EACRLF
yy/mo/dd_hh:mm:ss_xxx_mmm...mCRLF
.........................................
ENCRLF
yy Year (00 to 99)
mo Month (01 to 12)
dd Day (01 to 31)
hh Hour (00 to 23)
mm Minute (00 to 59)
ss Seconds (00 to 59)
xxx Command number (001 to 100, ---)
mmm...m Command status
_
Blank
Example
EA
99/05/11 12:20:30 --- START
99/05/11 12:20:31 001 CONNECTING
99/05/11 12:20:32 001 VALID
EN
List of Character Codes Showing Modbus Master Command Statuses
The table below also includes character codes that are only used by either the
Modbus master or Modbus client.
Command Meaning
Status
SKIP
Command not set
INVALID Cannot execute command
NO_DATA Data could not yet be acquired
VALID Data successfully acquired
STALE Data became old (acquisition error)
WAITING Server/slave communication recovery waiting
CLOSED Connection with server/slave closed
RESOLVING Establishing connection with server/slave (address being resolved)
CONNECTING Establishing connection with server/slave (requesting connection)
UNREACH
Failed to connect to server/slave (not found)
TIMEDOUT Failed to connect to server/slave (time out occurred)
BROKEN Response message damaged (CRC error)
ERROR Response message was an error message
BAD_SLAVE Slave address of response message invalid (does not match command)
BAD_FC Response message function code invalid (does not match command)
BAD_ADDR Response message address invalid (does not match command)
BAD_NUM Response message register invalid (does not match command)
BAD_CNT Number of response message registers invalid (does not match command)
BAD_DATA Conversion of response message data failed
2.2 ASCII Output