Yokogawa Standalone MW100 - Manual (Page 18)

1-11
IM MW100-17E
Commands
1
2
3
App App
Index
Action Types
The following shows the action types available for Event/Action settings (SL commands).
Action Types
Action Types Description
MEMORY_START Starts recording
MEMORY_STOP Stops recording
MEMORY_SAVE Divides and Saves the measured/computed data file
MEMORY_SAVE_T Divides and saves the thinned data file
MATH_START Starts computation
MATH_STOP Stops computation
MATH_CLEAR Clears the computation
MATH_RESET Resets computation
MATH_RST_GR1 Resets computation on MATH group 1
MATH_RST_GR2 Resets computation on MATH group 2
MATH_RST_GR3 Resets computation on MATH group 3
MATH_RST_GR4 Resets computation on MATH group 4
MATH_RST_GR5 Resets computation on MATH group 5
MATH_RST_GR6 Resets computation on MATH group 6
MATH_RST_GR7 Resets computation on MATH group 7
TRIGGER1 Activates trigger 1
TRIGGER2 Activates trigger 2
TRIGGER3 Activates trigger 3
ALARM_ACK Checks the alarm status
FLAG Sets the flag to a value
TIMER1_RESET Resets timer 1
TIMER2_RESET Resets timer 2
TIMER3_RESET Resets timer 3
TIMER4_RESET Resets timer 4
TIMER5_RESET Resets timer 5
TIMER6_RESET Resets timer 6
MESSAGE0 Writes message 0 (Free message) in the data file being
acquired
MESSAGE1 Writes message 1 in the data file being acquired
MESSAGE2 Writes message 2 in the data file being acquired
MESSAGE3 Writes message 3 in the data file being acquired
MESSAGE4 Writes message 4 in the data file being acquired
MESSAGE5 Writes message 5 in the data file being acquired
FILE_SAVE Saves settings files
FILE_LOAD Loads settings files
MANUAL_SAMPLE Executes manual sample recording
MANUAL_DIVIDE Divides manual sample files
• You cannot set same action type for EDGE and LEVEL.
* The following action types are judged as being the same.
MEMORY_START and MEMORY_STOP
MATH_START and MATH_STOP
FLAG of the same flag number
• You cannot set same action type for multiple LEVELs.
* The following action types are judged as being the same.
MEMORY_START and MEMORY_STOP
MATH_START and MATH_STOP
FLAG of the same flag number
The above setting errors occur when transitioning from Setting mode to Measurement
mode.
1.3 Parameters