Yokogawa Standalone MW100 - Manual (Page 35)

1-28 IM MW100-17E
Explanation • Set p5 (recording interval) to an integer multiple of the
measurement interval.
The recording interval can be set to 1, 2, 4, or 10 if
the measurement interval is 50 mS, 500 mS, or 5 S.
The recording interval can be set to 1, 5, or 10 if the
measurement interval is 200 mS.
The recording interval can be set to 1, 2, 5, or 10 for
all other measurement intervals.
ML Recording Data Length Settings
Setting MLp1<terminator>
p1 Data length when the recording
start timing is set to DIRECT under
recording operation
30 M (units of minutes)
1H/2H/3H/4H/6H/8H/12H (units of
hours)
1D/2D/3D/5D/7D/10D/14D/31D (units of
days)
Query ML?
Example Set the recording start time data length to 1 hour.
ML1H
MR Recording Free Space Settings
Setting MRp1<terminator>
p1 Recording time remaining on media set
for small media free space
1H/2H/3H/4H/5H (units of hours)
Query MR?
Example Set media free space to 2 hours.
MR2H
MX Thinning Recording Operation
Settings
Setting When p1=OFF
MXp1<terminator>
When p1 is not OFF
MXp1,p2,p3<terminator>
p1 Recording interval:
OFF (do not record)
4S/5S/10S/20S/30S (units of seconds)
1M/2M/3M/4M/5M/10M/20M/30M (units of
minutes)
1H (units of hours)
p2 Recording stop action
SINGLE Recording stops after
creating one file
FULLSTOP Recording stops when file is
full
ROTATE Continue recording by
deleting the old data
p3 Recording data length
30 M (units of minutes)
1H/2H/3H/4H/6H/8H/12H (units of
hours)
1D/2D/3D/5D/7D/10D/14D/31D (units of
days)
Query MX?
Example Set recording interval to 1H, recording operation to
FULLSTOP, and recording data length to 2D.
MX1H,FULLSTOP,2D
Explanation • p3 cannot be set to a time less than the p1 interval.
• The relationship between the measurement and
MATH intervals set on the input module and the
allowed thinning recording interval setting is shown
in the table below.
4S
5S
10S
20S
30S
1M
2M
3M
4M
5M
10M
20M
30M
1H
10ms, 50ms, 100ms
200ms, 500ms, 1s














2s













10s












Measurement Interval (Measurement Group/MATH Interval)
5s













20s










30s










60s









 : Can be set, Blank: Cannot be set
Thinning
Recording
Interval
MU Setting Save Operation Settings
Setting MUp1,p2,p3,p4<terminator>
p1 Saving of channel related settings
OFF/ON
p2 Saving of recording related settings
OFF/ON
p3 Saving of communication related
settings OFF/ON
p4 Saving of other settings OFF/ON
Query MU?
Example Set so that all settings are saved.
MHON,ON,ON,ON
XK Key Lock Settings
Setting XKp1<terminator>
p1 Key lock OFF/ON
Query XK?
Example Key lock settings.
XKON
Explanation The setting is valid in Setting mode or Measurement
mode.
1.4 Setting Commands (System Related)