Martel Electronics BetaGauge 3II - Manual (Page 108)

6-23 Application Notes
SYS Mode
There are two methods for configuring an electrical to
electrical calibration test using SYS mode. The
following table indicates which method to use.
Use this method if…
Method 1
 Your field instrument has an
electrical output range within the
ability of the DC module on the
BetaGauge II.
Method 2
 Your field instrument has an
electrical output range that exceeds
the ability of the DC module on the
BetaGauge II.
NOTE: While in SYS mode, the BetaGauge II cannot
measure the electrical input signals to the field
instrument. You must manually enter the value
of these signals on the BetaGauge II.