Martel Electronics BetaGauge 3II - Manual (Page 154)

7-13 Doc. Cal. Mode
Accessing the Execute Level
To access the Execute level of the SYS mode, press the
function key corresponding to Exe on the Back screen.
The Test Setup screen appears as shown below:
The Test Setup screen is described below and on the
following page.
Test Setup Screen Description
The main purpose of the Test Setup screen is to indicate
whether you have installed modules with the proper
range for the assigned test point values of the current
tag. In addition, you can ensure that the currently
installed modules have not exceeded their calibration
interval.
NOTE: You cannot proceed from the Test Setup
screen until you have installed modules that
will accommodate the assigned test point
values for the current tag.
Tag 2:
BG2 TAGS Tag 2
Inst. OUT: mA
4.0000 20.000 CH1
Inst. IN: PSI
3.0000 15.000 CH2
CH1 DC
09/25/1995
CH2
GAGE
04/16/1995 15.00
Modules Correct
Ready