Martel Electronics BetaGauge 3II - Manual (Page 80)

5-13 Advanced Display Modes
6. After you select the field instrument type, the main
linearization screen displays. Use this screen to
begin defining the expected low and high values for
the field instrument’s input and output scales as
described in the next procedure.
Defining the Expected Low/High Values
1. After you define the field instrument type, the
following main linearization screen displays:
In the above example:
x = the channel number of the DC module,
yyyy = the current linearization mode of the DC
module channel.
2. Press the function key corresponding to the 
menu item, and the following screen displays:
3. Press the function key corresponding to %Err and
the display screen prompts you for the field
instrument’s in/out low value. A sample screen is
shown below:
4. Use the keypad numbers to enter the value of the
signal expected for the low end of the field
instrument’s output scale, then press the ENTER
key.
CHx Mode: yyyy
Std Eng Sqrt →
CHx Mode: yyyy
%Scal %Err →
CHx Instr: Out Lo