Martel Electronics BetaGauge 3II User Manual
Page 129
Advertising
Application Notes
6-44
Electrical Indicator or Loop Test
You can perform an electrical indicator or loop
calibration using either the conventional mode or the
SYS mode of operation. The following paragraphs
describe all of the possible configurations, as well as,
the other equipment necessary to perform an electrical
indicator test.
Conventional Mode
You may perform this test if:
Your field instrument has an electrical input
range within the ability of the DC module on
the BetaGauge II.
Field Instrument Setup
Electrical input
Electrical indicator output (requires manual
entry on the BetaGauge II)
Other Necessary Equipment
Electrical source
Advertising