Martel Electronics BetaGauge 3II - Manual (Page 12)

xi
Introduction
The BetaGauge II™ Pressure Calibrator is the most
advanced and accurate handheld pressure calibrator
available. This calibrator was engineered to perform in
any industrial environment and is equipped with
everything you need for maintaining your pressure
instruments to your manufacturer’s specifications.
About this Guide
This guide provides complete information on the proper
use and operation of the BetaGauge II. A brief
description of each section follows:
Section 1 provides general information regarding the
BetaGauge II, as well as a description of the keyboard
and menu. In addition, it provides information on
standard and optional equipment.
Section 2 describes the two types of input modules
available for the BetaGauge II. It also explains how to
install and remove modules and how to connect field
devices to both module types.
Section 3 explains how to perform basic BetaGauge II
operations, such as specifying pre-programmed display
units, zeroing displayed values, and programming trip
detection.
Section 4 explains how to set user preferences, such as
viewing and programming owner and calibrator
information, turning the keypad beep on and off, and
setting LCD preferences.
Section 5 explains how to set up user-defined display
modes for both electrical and pressure units.
Section 6 explains how to perform the possible
calibration tests using the BetaGauge II.