Martel Electronics BetaGauge 3II - Manual (Page 91)

Application Notes 6-6
SYS Mode
There are two methods for configuring an electrical to
pressure calibration test using SYS mode. The
following table indicates which method to use.
Use this method if…
Method 1 Your field instrument has a pressure
output range within the ability of the
pressure module on the BetaGauge II.
Method 2 Your field instrument has a pressure
output range that exceeds the ability of
the pressure module on the BetaGauge
II.
NOTE: While in SYS mode, the BetaGauge II cannot
measure the electrical input signals to the field
instrument. You must manually enter the value
of these signals on the BetaGauge II.
Method 1
Software Instrument Setup
 Electrical input (requires manual entry on the
BetaGauge II)
 Pressure output
Other Necessary Equipment
 Electrical source