Martel Electronics BetaGauge 3II - Manual (Page 139)

Application Notes 6-54
Temperature Indicator or Loop Test
You can perform a temperature indicator or loop
calibration using only the SYS mode of operation. The
following paragraphs describe the possible
configurations, as well as, the other equipment
necessary to perform a temperature indicator test.
SYS Mode
You may perform this test if:
 You are using either a local or remote
temperature indicator to indicate the
temperature input signal to the field
instrument.
NOTE: The BetaGauge II cannot make direct
temperature measurements.
Software Instrument Setup
 Temperature input (requires manual entry on
the BetaGauge II)
 Temperature indicator output (requires manual
entry on the BetaGauge II)
Other Necessary Equipment
 Temperature source