Martel Electronics BetaGauge 3II - Manual (Page 69)

Advanced Display Modes 5-2
Procedure
Use the following procedure to define a pressure unit of
your choice:
1. Press CH1 or CH2 to indicate the appropriate bay
in which the pressure module is installed.
2. Use the MENU key to locate the Setup menu item
User, then press the corresponding function key to
display the following screen:
In the above example:
x = the channel number of the pressure module,
yyyy = the current user unit label.
3. Specify a unit label by using the CLR key to erase
the character (if any) to the left of the cursor and
use the arrow keys on the keypad to scroll through
the available character set. When the desired
character is displayed, press the ENTER key to
accept the character and move the cursor to the
right. A maximum of 4 characters may be entered
for identification.
NOTE: Pressing the ENTER key twice in a row
ends editing. Therefore, to specify the same
character consecutively, use the up and down arrow
keys to select the second character.
For the example Feet of Water Column at 20°C,
you would enter FTWC.
CHx Ent. Unit: yyyy