Martel Electronics BetaGauge 3II User Manual
Page 131
Advertising
Application Notes
6-46
SYS Mode
You may perform this test if:
You are using either a local or remote
electrical indicator to indicate the electrical
input signal to the field instrument.
NOTE: While in SYS mode, the BetaGauge II
cannot measure the electrical input signals to the
field instrument. You must manually enter the
value of these signals on the BetaGauge II.
Software Instrument Setup
Electrical input (requires manual entry on the
BetaGauge II)
Electrical indicator output (requires manual
entry on the BetaGauge II)
Other Necessary Equipment
Electrical source
Advertising