Martel Electronics BetaGauge 3II - Manual (Page 4)

iv
3- Basic Operations ......................................... 3-1
Overview................................................................ 3-1
Selecting a Channel for Specific Functions ........... 3-2
Procedure ........................................................... 3-2
Selecting Pre-Programmed Display Units.............. 3-3
BetaPort–DC Module ........................................ 3-3
BetaPort–P Pressure Module ............................. 3-4
Selecting a Water Column Measurement ....... 3-5
Procedure ................................................... 3-6
Zeroing Modules.................................................... 3-6
Zeroing Pressure Modules ................................. 3-7
Zeroing a Gauge Zero Reference Module...... 3-7
Zeroing an Absolute Zero Reference Module 3-8
Zeroing DC Modules .......................................3 -10
Zeroing the Volts Input ................................3 -10
Zeroing the Milliamp Input ..........................3 -11
Setting the Damping Factor for Ch1/Ch2 ............3 -12
Reset Damping Guidelines............................... 3 -13
Procedure ......................................................... 3 -13
Viewing Module Information ..............................3 -14
Procedure ......................................................... 3 -14
Programming Trip Detection ............................... 3 -15
Wet Contacts....................................................3 -15
Dry Contacts ....................................................3 -16
Hints for Accurate Trip Measurements............3 -16
Field Instrument Selection ........................... 3 -16
Pressure Source Adjustment ........................3 -17
Pressure Signal Ramping ............................. 3 -17
Preliminary Setup ............................................3 -18
Procedure ......................................................... 3 -19
4- User Preferences ......................................... 4-1
Overview................................................................ 4-1
Programming and Viewing Calibrator Information 4-2
Entering Owner Identification ........................... 4-2
Viewing Calibrator Information......................... 4-3
Turning the Keypad Beep On/Off.......................... 4-3
Procedure ........................................................... 4-3