Martel Electronics BetaGauge 3II - Manual (Page 73)

Advanced Display Modes 5-6
Defining the Field Instrument Type
To define the type of field instrument you want to
calibrate, do the following:
1. Use the Menu key to locate the Setup menu item
Mode, then press the corresponding function key to
display the following screen:
2. Press the corresponding function key to select the
type of field instrument you want to calibrate: P/I,
I/P, or Other.
3. If you select Other, the following screen will
display:
4. Do one of the following:
 To indicate that you want the DC module to be
the field instrument input, select the function
button corresponding to the DC module’s
present channel.
 To indicate that you want the DC module to be
the field instrument output, select the opposite
channel.
NOTE: Input and output references are with
respect to the field instrument.
5. After you select the field instrument type, the main
linearization screen displays. Use this screen to
begin defining the engineering low and high values
as described in the next procedure.
Calib Instr
P/I I/P Other
Instrument Input:
CH1 CH2