Martel Electronics BetaGauge 3II - Manual (Page 17)

General Description 1-2
Carrying Case
The BetaGauge II comes with a two-section padded
vinyl carrying case. It is recommended that you use the
case at all times to protect the calibrator from damage
due to chemicals, dust, and dirt. The carrying case is
described below:
Front Section. The calibrator is secured in the front
section of the case with an elastic strap that fits between
the keypad and the display.
Back Section. The back section of the case provides
space for carrying three modules, this user guide, and
communications cables. There is also space for fittings
or other connectors, if needed.
Bottom Flap. A flap at the bottom of the case is
secured with Velcro™. You can loosen the flap to
install and use modules while the calibrator is in the
case. Keep the flap closed when the calibrator is not in
use to keep foreign material out of the module bays.
Front Flap. The flap at the front of the case has a
pouch for holding the calibrator test leads.
Carrying Strap. The carrying strap on the case may be
adjusted for comfort as a shoulder strap (or you can
remove the strap). It can also be used to hang the
calibrator for use in the field.