NORD Drivesystems BU0180 - Manual (Page 131)

6 Parameterisation
BU 0180 GB-0914 Pre-series version 131
Parameter Setting value / Description / Note Device Supervisor
Parameter
set
P727
Mechanical power
(Mechanical power)
-99.99 ... 99.99 kW Displays the actual calculated effective power of the motor. Basis for calculation are the motor
data P201...P209.
P728
Input voltage
(Input voltage)
0 ... 1000 V Displays the actual mains voltage at the FI input.
P729
Torque
(Torque)
-400 ... 400 % Displays the actual calculated torque. Basis for calculation are the motor data P201...P209.
P730
Field
(Field)
0 ... 250 % Displays the actual field in the motor as calculated by the inverter. Basis for calculation are the
motor data P201...P209.
P731
Parameter set
(Actual parameter set)
0 ... 3 Shows the actual operating parameter set.
0 = Parameter set 1
1 = Parameter set 2
2 = Parameter set 3
3 = Parameter set 4
P732
U phase current
(U phase current)
S
0.0 ... 999.9 A Displays the actual U phase current.
NOTE: This value can deviate somewhat from the value in P719, due to the measurement
procedure used, even with symmetrical output currents.
P733
V phase current
(V phase current)
S
0.0 ... 999.9 A Displays the actual V phase current.
NOTE: This value can deviate somewhat from the value in P719, due to the measurement
procedure used, even with symmetrical output currents.
P734
W phase current
(W phase current)
S
0.0 ... 999.9 A Displays the actual W phase current.
NOTE: This value can deviate from the value in P719, due to the measurement procedure
used, even with symmetrical output currents.
P735 Reserved
P736
Link voltage
(DC link voltage)
0 ... 1000 V DC Displays the actual link voltage.