NORD Drivesystems BU0180 - Manual (Page 73)

5 Commissioning
BU 0180 GB-0914 Pre-series version 73
Procedure for SK 190E:

Ensure power supply of the ASi interface via the yellow ASi cable.

Disconnect the AS-i master during addressing

Set the address ≠ 0

Do not doubly assign addresses
Normal hand-held units can be used for the addressing of the frequency inverter. Typical manufacturers are
Pepperl+Fuchs (e.g.: VBP-HH1-V3.0-V1) and IFM (E.g.: AC1154).
The following lists the possibilities for the practical implementation of addressing an SK 190E with an
addressing box.
Version 1
With
a normal addressing device
(equipped with an M12 plug for
connection to the AS-i bus) the AS-i can
be integrated into the AS-i network via a
suitable access point. The prerequisite for
this is that the AS-i master can be
switched off.
Version 2
With an addressing unit (equipped with
an M12 plug for connection to the AS-i
bus and an additional M12 plug for an
external power supply), the addressing
unit can be directly connected into the
AS-i cable.
NOTE
With the SK 190E a battery-operated addressing device is sufficient.
AS-i addressing unit
AS-i -
MASTER
AS-i -
Power
AS-i addressing unit
AS-i cable