5 parameters, P547 digital bus setpoint 2, P548 digital bus setpoint 3 – NORD Drivesystems BU0060 User Manual

Page 85: P551 drive profile, P560 parameter, saving mode

Advertising
background image

5 Parameters

BU 0060 GB-4112

85

P547

Digital Bus setpoint 2

(Function of bus setpoint 2)

S

P

0 ... 55

{ 0 }

This parameter is identical to P546.

Pos : 158 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P500-P599/ Paramet er P548 – Funkti on Bus-Soll wert 3 [ SK 500... 535E] @ 0\ mod_1328098278323_388. doc x @ 11985 @ @ 1

P548

Digital Bus setpoint 3

(Function of bus setpoint 3)

S

P

0 ... 55

{ 0 }

This parameter is identical to P546.

Pos : 159 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P500-P599/ Paramet er P551 – Antriebs profil @ 0\ mod_1328098517139_388. doc x @ 12054 @ @ 1

P551

Drive profile

(Drive profile)

S

0 … 1

{ 0 }

According to the option the relevant process data profiles can be activated with this parameter.

Note

Activation of profiles

This parameter is only effective for pluggable technology modules (SK TU3-…).

System

CANopen

DeviceNet

InterBus

Technology module

SK TUx-CAO

SK TUx-DEV

SK TUx-IBS

Setting

0 = OFF =

USS protocol (Profile "Nord")

1 = ON =

DS402 profile

AC Drives profile

Drivecom profile

Pos : 160 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P500-P599/ Paramet er P560 – Paramet er Speic hermode @ 0\ mod_1328098918376_388. doc x @ 12238 @ @ 1

P560

Parameter, Saving mode

(Saving mode parameter)

S

0 ... 2

{ 1 }

0 = Only in RAM, changes to the parameter settings are no longer saved on the EEPROM.

All previously saved settings are retained, even if the FI is disconnected from the mains.

1 = RAM and EEPROM, all parameter changes are automatically written to the EEPROM

and remain stored there even if the FI is disconnected from the mains supply.

2 = OFF, no saving in RAM and EEPROM possible (no parameter changes are accepted)

NOTE: If BUS communication is used to implement parameter changes, it must be ensured

that the maximum number of write cycles (100,000 x) in the EEPROM is not
exceeded.

Pos : 161 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ P7xx I nf or mationen @ 0\ mod_1328170311705_388. doc x @ 12293 @ 5 @ 1

Advertising