Appendix 1: serial commands – Vaisala HMP240 User Manual
Page 71
HMP240
M210300en
Appendix 1: Serial commands
69
APPENDIX 1: SERIAL COMMANDS
1.
ANALOGUE OUTPUT COMMANDS ......................................................................... 70
2.
CALIBRATION COMMANDS .................................................................................... 73
3.
OUTPUT VIA THE SERIAL BUS ............................................................................... 77
3.1
Operation modes.......................................................................................... 84
4.
OTHERS ................................................................................................................... 86
The commands function as described when the serial interface is in full-
duplex mode and echo is on. All commands except FORM can be given in
either capital or small letters.
In the commands <cr> means carriage return, <lf> line feed and <ht> hori-
zontal tabulation.