Vaddio Canon VC-C50i Programmers - Manual (Page 140)

139
14.13 Remote Control OFF
System Control Command Type 1
Function To inhibited remote control
Command 0080h
Length 1 byte Parameter
Value 1h
Status None
Reference •To set remote control ON by default during power ON.
•By issuing this command, remote control forbidden flag sets 1 and not
receive key code from remote control
•Not to execute remote control through operation under remote control OFF,
even though remote control through command ON comes out. (See 9.
Function of Remote Control)
Format of Control Code
d0 d1 d2 d3 d4 d5 d6
Header Device Num Command Parameter End mark
FFh 30h 3Xh 00h 80h 31h EFh
Answer Format
d0 d1 d2 d3 d4 d5
Header Device Num Error Code End mark
FEh 30h 3Xh e0 e1 EFh
⇓
Error Flag indicates in 2 figures hexadecimal and returns ASCII code value
Example: e0 e1
In case of No Error :
00000000B ⇒ 00h ⇒ 30h 30h
In case of Busy : 00010000B ⇒ 10h ⇒ 31h 30h
In case of Parameter Error : 01010000B ⇒ 50h ⇒ 35h 30h
In case of Mode Error : 10010000B ⇒ 90h ⇒ 39h 30h
Condition of Error flag to be set
Busy •In case of executing Camera Control command.
•In case of executing Pedestal Control command.
•In case of executing Preset Move command.
Parameter Error •In case of assigned parameter illegal.
Mode Error
•Not in status of Camera ON.
•Not in status of Host Control Mode.