Vaddio Canon VC-C50i Programmers - Manual (Page 151)

150
14.21 Preset Move System Control Command Type 2
Function To move to Pan angle (position), Tilt angle (position), zoom position and AE
target value (Brightness value) stored in assigned preset memory address.
Command 008Ah
Parameter Length
1 byte
Value 1~9
Status None
Reference •This command is uneffective until to store preset position by remote control
operation or Preset set Command, since nonvolatile memory is unused at the
factory shipping moment. (return without answer error)
•By issuing this command, start Pan/Tilt/Zoom/AE Target value operations to
the assigned Preset position, and flags in operation of Pan/Tilt/Zoom come
out 1. When each operation reaches to Preset position, all of operation will
stop and corresponding flags be cleared to zero. (Flag corresponding to AE
Target Compensation Operation doesn't exist among of status in operation)
•Necessary to confirm Termination Notification Answer to this command by
setting Command Termination Notification ON, in order to confirm
Termination of Shift Operation by this command.
•The running speed of this command is reflective of the speed assigned by
Pan/Tilt Speed Assignment (12.1,12.2), Zoom Speed Assignment (13.20)
commands.
•By this command, Pan/Tilt, Zoom Movement operations or Pan/Tilt Stop
command (12.5 or 12.23) stop.
But AE target value compensation operation doesn't stop.
Note:
After power ON, return mode error and execute Pedestal Initialize 2, at the
moment to receive this command without executing Pedestal Initialize 1 &
Pedestal Initialize 2 commands.
Format of Control Code
d0 d1 d2 d3 d4 d5 d6
Header Device Num Command Parameter End mark
FFh 30h 3Xh 00h 8Ah p0 EFh
⇓
Memory address (1~9) to be called indicates in ASCII 1 byte.
Example: move to Pan/Tilt angle and Zoom position stored in memory address 2
p0
2 ⇒ 02h ⇒ 32h