WIKA CPC6000 User Manual
Page 18
Automated Pressure Calibrator
CPC 6000
18
Mensor/WIKA Operating Instructions - CPC 6000
3.6 Pneumatic Module
Pneumatic modules come in two types and are referred to in this manual as the “Pump Regulator”
or the “Solenoid Valve Regulator”. The pump regulator is used with low pressure sensors specified
in
Section 4
, Specifications. The solenoid valve regulator is used with higher pressure sensors and
comes in three varieties:
High Pressure Solenoid Valve Regulator (HP SVR)
Medium Pressure Solenoid Valve Regulator (MP SVR)
Low Pressure Solenoid Valve Regulator (LP SVR)
Pressure limits for all of these are specified in Section 4, Specifications.
Each pneumatic module (Figure 3.6) includes platforms for up to two high performance pressure trans-
ducers which are traceable to NIST standards. Both of these transducers can be used in conjunction
with the highly stable pressure regulator to produce a precise pressure output. Each transducer in-
cludes its own on-board compensation and calibration data so that any transducer can be replaced in
the instrument without requiring a recalibration.
Figure 3.6 - Pneumatic Module
■
■
■