WIKA CPC6000 - Manual (Page 35)

Automated Pressure Calibrator
CPC 6000
Mensor/WIKA Operating Instructions - CPC 6000 35
6.4 [Program] Key
The [Program] key on the bottom left of the operation screen (see Figure 6.3B) enters the main pro-
gram creation/edit screen shown in Figure 6.4A. Programmed multi-step sequences can be entered
and edited from this screen. There are sample programs available in the instrument that can be edited
and renamed. A saved program can be executed by entering the setup channel screen and selecting
the [Program] key. The CPC 6000 can store up to 64 programs with up to 100 steps in each program.
Figure 6.4A - Main Program Screen
The large key at the top of this screen contains the program name of the currently active program that
can be run or edited. If this key is pressed, a list of saved programs will be displayed as shown in Fig-
ure 6.4B. The up and down arrow keys display additional pages of programs. To select a program to
run or edit, simply press the name of the program.
To create a new program sequence, select a blank line and press [OK]. To copy an existing program,
select the program to be copied, press [Copy], select a new line (or an existing program to overwrite)
and press [Paste]. The [Delete] key erases a program from memory.
Figure 6.4B - Program Selection Screen