WIKA CPC6000 - Manual (Page 19)

Automated Pressure Calibrator
CPC 6000
Mensor/WIKA Operating Instructions - CPC 6000 19
3.7 Chassis Assembly
The chassis assembly acts as the housing for the system. The electrical and pneumatic modules are
each self-contained inside the chassis, and either can be replaced using basic hand tools. In addition,
each pressure transducer is individually removable without tools. Instructions for transducer and mod-
ule removal are provided in
Section 9 , Maintenance.
The only moving parts in the CPC 6000 are the fan, the pneumatic flow controller diaphragms and
valves, the pump/motor, and the solenoid valve plungers. There are no internal user adjustments or
setup switches.
Figure 3.7 - Chassis Assembly