WIKA CPC6000 User Manual
Page 74
Automated Pressure Calibrator
CPC 6000
74
Mensor/WIKA Operating Instructions - CPC 6000
8.6.2 Screen Source
The CPC 6000 has two frames in which channel information can be displayed. The frame channel
source can be programmed to A(left) B(right) or A(left) Delta(right) or Delta(left) B(right). Either frame
can be minimized as before.
8.6.3 Configure Button
In order to allow the delta function and frame channel source to be changed, a new button was added
to the lower toolbar. This button is labeled ‘Configure’ and only appears when the Delta function is
enabled. Pressing this button brings up a window with radio buttons to select the desired configura-
tion as shown in Figure 8.6.3.
Figure 8.6.3 - Configure Button Display Screen
8.6.4 Slave Channel Display
Since the range information is not applicable to the delta channel, the slave channel (the physical one
not displayed) reading is displayed where the range droplist appears in the normal screen.
8.6.5 Screen Source A B
Channels are completely independent. Operates just like a standard CPC 6000.