WIKA CPC6000 - Manual (Page 8)

Automated Pressure Calibrator
CPC 6000
8 Mensor/WIKA Operating Instructions - CPC 6000
These directives are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be required to correct the interference
at his or her own expense.
Use shielded cables to connect external devices to this instrument to minimize RF radiation.
1.4 Trademarks and Copyrights (C)
Mensor is a registered trademark of Mensor Corporation. All other brand and product names are
trademarks or registered trademarks of their respective companies. ©2006, Mensor Corporation. All
rights reserved.
Korean font: Copyright (C) 1987, 1988; Daewoo Electronics Co., Ltd.
Chinese font: Copyright (C) 1988; The Institute of Software, Academia Sinica.
Correspondence address: P.O. Box 8718, Beijing, China 100080.
1.5 Software License Agreement
This product contains intellectual property, i.e., software programs, that are licensed for use by the end
user/customer (hereinafter “end user”).
This is not a sale of such intellectual property.
The end user shall not copy, disassemble or reverse compile the software program.
The software programs are provided to the end user “as is” without warranty of
any kind, either express or implied, including, but not limited to, warranties of
merchantability and fitness for a particular purpose. The entire risk of the quality
and performance of the software program is with the end user.
Mensor and its suppliers shall not be held to any liability for any damages suffered or incurred by the
end user (including, but not limited to, general, special, consequential or incidental damages including
damages for loss of business profits, business interruption, loss of business information and the like),
arising from or in connection with the delivery, use or performance of the software program.
1.6 Mensor Service Plus
If you have problems using your CPC 6000 and you don’t find the answer in this manual, contact Men-
sor at 1.800.984.4200 (USA only), or 1.512.396.4200 for personal assistance, or at any of the on-line
addresses listed by touching the Mensor logo on the screen. We are ready to help.
1.6.1 After the Warranty
Mensor’s concern with the performance of this instrument is not limited to the warranty period. We
provide complete repair, calibration and certification services after the warranty for a nominal fee as
explained in
Section 9 , Maintenance.
i
Notice
i
Notice