JLG 1350SJP Service Manual - Manual (Page 105)

SECTION 3 - CHASSIS & TURNTABLE
3121142 – JLG Lift – 3-59
12. Disassemble the Ø160 inner snap ring and pull the
spring holder spacer out. Remove the springs and using
a compressed air jet in the brake control hole pull the
piston out of the spindle.
13. Remove the brake discs and seals.
14. Fit the ball bearing into the input shaft and lock it with a
Ø40 outer snap ring. Then mount the motor shaft in the
spindle and lock with a BR68 ring. Lubricate the bearing.
Assembly
1. Make sure all the component parts of the wheel gear are
devoid of burrs, machining residues and that they are
correctly washed.
2. Fit the ball bearing in the input shaft and lock with a Ø40
outer snap ring.
3. Mount the motor shaft in the spindle and lock with BR68
ring. Lubricate the bearing.