JLG 1350SJP Service Manual - Manual (Page 267)

SECTION 4 - BOOM & PLATFORM
3121142 – JLG Lift – 4-33
16. Feed the fly boom retract cable into the inner mid boom
section from the front.
17. Using an adequate lifting device, align the outer mid
boom section with the inner mid boom section.
18. Attach the fly boom retract cables in the inner mid
boom section to the receptacles at the rear of the outer
mid boom section.
19. Put tape over the holes to keep the cable ends from
jumping out.
20. Push the outer mid assembly part way into the inner
mid boom section. Apply JLG Threadlocker P/N 0100011
to the bolts and install the front bottom wear pad into
the inner mid boom section. Torque the bolts to 50
ft.lbs. (68 Nm).