JLG 1350SJP Service Manual - Manual (Page 255)

SECTION 4 - BOOM & PLATFORM
3121142 – JLG Lift – 4-21
25. Remove the outer mid retract cables from the attach-
ment fixtures at the front of the boom base section.
26. Attach an auxiliary hydraulic power source to the tele-
scope cylinder and extend the cylinder rod enough to
turn the trunnion in a vertical position.
27. Pull the inner mid, outer mid, and fly boom sections out
of the base boom section. Use additional lifting devices
and reposition any lifting straps as necessary as the sec-
tions are withdrawn. It will be helpful during this step to
pull the outer mid retract cable out from the front of the
base section as the other sections are being pulled out.
This will prevent the cables from tangling as the sections
are withdrawn.