JLG 1350SJP Service Manual - Manual (Page 129)

SECTION 3 - CHASSIS & TURNTABLE
3121142 – JLG Lift – 3-83
5. If the end cover (2) is equipped with shuttle valve com-
ponents, remove the two previously loosened plugs
(21).
BE READY TO CATCH THE SHUTTLE VALVE OR RELIEF VALVE COMPONENTS
THAT WILL FALL OUT OF THE END COVER VALVE CAVITY WHEN THE PLUGS ARE
REMOVED.
NOTE: The insert and if included the orifice plug in the end cover
(2) must not be removed as they are serviced as an integral
part of the end cover.
1. Special Bolts
2. End Cover
3. Seal Ring-Commutator
4. Seal Ring
5. Commutator Ring
6. Commutator Ring
7. Manifold
8. Rotor Set
8A. Rotor
8B. Stator or Stator Vane
8C. Vane
8D. Stator Half
9.
Wear Plate
10. Drive Link
11. Not Used
12. Coupling Shaft
13. Bearing/Bushing, Inner
14. Thrust Washer
15. Thrust Bearing
16. Seal
17. Back-up Washer
18. Housing
18A. O-Ring
19. Bearing/Bushing, Outer
20. Dirt & Water Seal
21. Plug
Figure 3-51. Swing Drive Motor