Boom sensor calibration position 10 -79 – JLG 1350SJP Service Manual User Manual
Page 455
Advertising
SECTION 6 - JLG CONTROL SYSTEM
3121142
– JLG Lift –
6-79
Press Enter. The screen will read:
32.
Telescope in to green witness mark (controller will find
the position - operator must visually verify the position).
When the boom is in the proper position, the screen will
read:
Press Enter. The screen will read:
33.
After completing all the Boom Sensors Calibrations, hit
ESC twice to go back to Calibrations.
34.
Cycle the emergency stop switch.
Figure 6-23. Boom Sensor Calibration Position 10
Advertising
This manual is related to the following products: